When this happened, tuners would be listed as " unknown" until TV Server was restarted. Sometimes TV Server was able to start before tuner drivers finished loading. TV Server usually starts automatically when Windows starts. not listed in Windows device manager (meaning tuner not installed or not detected during Windows startup)īefore MediaPortal 1.5 TV Server only detected tuners on startup.marked with a yellow exclamation mark in Windows device manager (meaning driver not installed or driver error).A tuner may be listed as " unknown" when it is: Tuners that are listed with type " unknown" are tuners that TV Server knows about but cannot use. Type This column describes the broadcast standard(s) that the tuner supports. ![]() The tuner with priority 1 is the tuner with the lowest priority it will be the last tuner that TV Server will try to use. If the first tuner fails to tune the channel for any reason then TV Server will automatically try each other tuner that is also available and capable of tuning the channel in order of descending priority. The tuner with the highest priority that is not in use on a different transponder or multiplex will be tried first. TV Server uses a priority system to decide which tuner to use for timeshifting and recording. ![]() Use the up and down buttons to change the priority settings for your tuners. This setting can be useful for testing or if you use some of your tuners with other software. Tick or untick the enabled check box to control whether the tuner is enabled or not. When a tuner is not enabled TV Server will not use it. * Note: *changes to tuner availability, priority and settings require a TV Server restart, so it is not recommended to change these settings while a recording is in progress. This section enables you to view and manage settings for the tuners that are installed in the server. When you click on the server name in the left panel you'll be presented with the following view. ![]() In the left pane the server node for " bagga-server" has been expanded to show the TV tuners associated with the server. Support for multiple "Slave Servers" was initially planned but this feature was disabled due to stability problems. There will always be only one Server listed. The tab in the above screenshot shows the configured server.
0 Comments
Leave a Reply. |